The Osprey Electronics E300 14 GH/s kHeavyHash miner might need been the primary FPGA miner in the marketplace for KASPA, nevertheless it apparently gained’t be the one one with extra FPGA and ASIC miners for KAS incoming. The E300 was initially priced at $4999 USD and is at present out there at $5199 USD with finish of Could supply with 400-500 Watts of energy utilization, however plainly the system is now dealing with competitors with the MultMiner M2 FPGA miner (apparently a rebranded Blackminer FPGA from HashAltCoin with kHeavyHash help) providing a hashrate of 8 GH/s at 1 kW or 10.5 GH/s at 1.3 kW in addition to DigyByte, Tellor, Qitmeer and Kadena help with a value of $2000+ USD. The opposite new choice is seemingly referred to as SuperScalar K10 kHeavyHash ASIC miner that guarantees 30 GH/s hashrate at 1700W of energy utilization with a value of round $8500-$10000 USD.
All of those FPGA and ASIC miners for KASPA (KAS) are fairly costly and though they do outperform the GPUs that almost all of us use for mining KAS for the time being, they nonetheless won’t be a superb funding and the rationale for that’s fairly easy – KASPA (KAS) is the one coin that at present makes use of the kHeavyHash algorithm and its block reward is lowering steadily every month (examine the emission curve for particulars) and consistently rising hashrate and issue. So, going for a really costly kHeavyHash ASIC miner that can’t mine the rest could be very dangerous and might simply get you to lose cash, it’s a lot wiser to speculate what you’d pay for the {hardware} to purchase KAS as a substitute, that would develop into a significantly better funding. The state of affairs with FPGAs is a bit higher as they may in principle be reprogrammed to mine different algorithms and cash, however there isn’t any assured that they are going to be, so nonetheless fairly dangerous and once more may be a better option to go for instantly investing in KAS than to purchase FPGA or ASIC miner to mine it with it.
Now, in case you occur to have an previous Blackminer F1, F1mini, F1+, F1mini+, F1-Extremely or an F2 bought again within the day from HashAltCoin, then you definitely would possibly need to concentrate right here as these obtained a firmware replace to help KASPA (KAS), though the bitstream to help the kHeavyHash algorithm is unusually referred to as “Kasper Bit”. Head on to HashAltCoin’s help part to obtain the brand new firmware updates for these gadgets that can carry you KAS help and relying on the {hardware} you will have you may be fortunate to get a “free” MultMiner M2 capabilities. Certainly will probably be a ok motive to revive these miners from the lifeless even whether it is only a small mini that isn’t that a lot highly effective it might nonetheless mine you some Kaspa cash at revenue because of the nice energy effectivity of those FPGAs.
Do be aware nevertheless that you just would possibly want to make use of proxy or a VPN if you’re based mostly on USA (possibly another nations as properly) with the intention to entry HashAltcoin’s official web site and be capable to obtain the firmware updates for the Blackminer!!!
Read the full article here
Discussion about this post